Publicidad
Idiomas disponibles
Idiomas disponibles
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
• Tighten the 4 screws (2) on the upper side of
the sliding table so that the sliding table can
be pushed easily without play.
• Push the stopper (1) back into the T-slot of the
sliding table base plate and tighten the screw.
8.4.
Align sliding table with work table
• Loosen the 4 nuts (1) on both brackets so that
the sliding table base profile still can be
moved.
• Level the edge of the sliding table with that of
the work table (straight piece of wood / spirit
level) until it is horizontally aligned without
gaps (2).
• After alignment, tighten all nuts (1) on both
sliding table brackets.
9. Assembly components on sliding table
9.1.
Work piece downholder
The work piece downholder is used for secure
fastening of workpieces.
NOTE:
There are 2 positions possible for
mounting the work piece downholder on the
sliding table (1): (V) for front position and (H) for
rear position.
• Insert the work piece downholder (2) with the
bracket (3) into the desired position (V) or (H).
• To secure the work piece downholder, tighten
the screw (4) with an allen key (5).
ASSEMBLY
48
TS200 | TS250
Publicidad
