Publicidad
Idiomas disponibles
Idiomas disponibles
16.4
Disposal
Observe the national waste disposal regulations. Never dispose of the machine,
machine components or equipment in residual waste. If necessary, contact your
local authorities for information on the disposal options available.
If you buy a new machine or an equivalent device from your specialist retailer, he is
obliged in certain countries to dispose of your old machine properly.
17
TROUBLESHOOTING
Danger due to electrical voltage!
Handling the machine with connected power supply may result in serious injury or
death.
Always disconnect the machine from the power supply before maintenance or
repair work and secure it against unintentional reconnection.
Many possible sources of error can be excluded in advance if the machine is properly connected to
the mains. If you are unable to carry out necessary repairs properly and/or do not have the required
training, always consult a specialist to correct the problem!
Trouble
Machine does not start
Motor switches itself off
Machine vibrates during
operation
Machine makes unusual
noises
The saw blade height is
difficult to adjust
Saw blade becomes blunt
quickly
Burn marks on the workpiece
Broken edges on the
workpiece
The finished dimension of the
processed workpiece does not
correspond to the cutting
width set on the rip fence
Workpiece jams while feeding
Wood is raised by the rear
side of the saw blade
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
WAR N I N G
Possible cause
1. Switch or a phase is broken
1. Machine overheated
2. Machine overloaded
1.
Clamping lever for fixation of saw
blade tilt is insufficiently fixed
2.
The hand wheel for saw blade tilting
is insufficiently fixed
1.
Bearings
2. V-belt loose
1.
The high of the spindle is difficult to
adjust
1.
Contaminated wood processed
(cement, nails, sand)
1.
The saw blade is blunt
2.
Saw blade is not mounted
correctly
1.
The saw blade or work tables are
incorrectly adjusted
2.
Saw blade is incorrectly mounted
1.
The ruler for the cutting width
display at the rip fence is set
incorrectly
1.
The saw blade is blunt
The work table is not clean
The riving knife thickness does not
match with the saw blade used
1.
Rip fence not correctly adjusted
2.
The riving knife is not correctly
aligned
3.
Saw blade does not match with
riving knife
TROUBLESHOOTING
Solution
1.
Repair the defective circuit or the
faulty phase
1.
Contact an electrician
2.
Feeding too rapid
Saw blade is dull
1.
Fix the clamping lever
2.
Fix the hand wheel for saw blade
tilting
1.
Inspect bearings, if necessary
replace them
2. Check the tension of the V-belt,
retighten if necessary
1.
Clean and lubricate the threaded
rod, gears and slideways
thoroughly.
2. Check the function of the
clamping lever
1.
Only process perfect material
1.
Replace the saw blade
2.
Check and, if necessary, correctly
mount the saw blade
1.
Adjust the saw blade or work
tables
2. Check and, if necessary, correctly
mount the saw blade
1.
Setting dimension scale: Cut the
workpiece at the rip fence,
measure the workpiece and
move the measuring scale so that
the correct cutting width can be
read off at the edge of the ruler
1.
Replace the saw blade
2.
Clean the worktable
3.
Riving knife thickness must be
greater than or equal to the saw
blade thickness
1.
Adjust rip fence
2.
Adjust riving knife
3.
The saw blade must be narrower
in relation to the riving knife
60
TS200 | TS250
Publicidad
