Descargar Imprimir esta página

HOLZMANN MASCHINEN TS200 230V Instrucciones De Servicio página 55

Publicidad

Idiomas disponibles

Idiomas disponibles

15.2.5
Blocking cross-cut fence
15.2.6
Mitre fence
15.3
Notes on using the machine
15.3.1
Selection of the saw blade
Apart from the material of the workpiece, the saw blade teeth play the most important role in
achieving precise cuts. The number of teeth, as well as their shape, arrangement and position
are associated with a specific function. To enhance the cutting quality, make sure that at least 2-
3 teeth cut through the workpiece at the same time. If only one tooth works, a poor working
surface results, the risk the vibrations and the noise exposure increases before setback increase:
adequate saw blade
Only work with well-sharpened saw blades.
Adjust the height of the saw blade so that the gear rim is reliably covered by the circular
saw blade guard (distance between saw blade guard and workpiece (maximum distance
of 5 mm).
Use the push stick at the end of cutting when the distance between the saw blade and
the ruler is less than 120 mm.
Make sure that the machine works without vibrations.
Cracked and deformed saw blades cannot be repaired. They must be sorted out
immediately as scrap and replaced by proper ones.
Feed the workpiece evenly, without thrusts and without taking it back, until the end of
cutting is reached.
15.3.2
Longitudinal cuts
When performing this operation, the following equipment shall be used for safe working:
Rip-fence
the guard of the saw blade
the riving knife
the insert in the table
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
The cross stop is secured laterally at the sliding table with a
stopper (1) against unintentional movement. With the screw (2)
the blocking can be raised or lowered.
The mitre fence can be inserted into the T-slots of the work
table on the right or left side of the saw blade.
By pivoting the mitre fence, cross cuts can be made at all angles
(see illustration on the left).
inadequate saw blade
OPERATION
55
TS200 | TS250

Publicidad

loading

Este manual también es adecuado para:

Ts250 230vTs250 400v