Publicidad
Idiomas disponibles
Idiomas disponibles
push stick when cutting small workpieces (distance between saw blade and fence
•
<120mm) and rip-fence with small
When cross-cutting round timber, a template or a holding device is necessary to
secure the workpiece against twisting and the use of a suitable saw blade is
necessary.
15.3.3
Mitre cuts (cross-cuts) and wedge-cutting
When performing this operation, the following equipment shall be used for safe working:
Mitre gauge
•
the saw blade guard
•
•
the riving knife
•
the tableinsert
Cross-cuts:
Mitre cuts in the range 0-90° can be carried out by pressing the workpiece to be cut firmly
against the stop surface of the mitre gauge.
Wedge cuts:
To do this, set the rotary part mitre fence to 0° and secure it with the adjusting handle. Position
the workpiece and saw through with even pressure.
Feed only with the hand on the mitre gauge (hands away from the wood).
Only remove workpieces (wedges) after the machine has come to a standstill. To do
this, switch off the machine and wait for the saw blade to come to a standstill.
15.3.4
Cutting boards
When performing this operation, the following equipment shall be used for safe working:
15.4
After working process
•
Switch off the machine
•
Disconnect the machine from the power supply.
Retract saw blade completely.
•
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
N O TI C E
C AU TI O N
WAR N I N G
The table extension
•
Cross-cut-fence or rip fence with support for the workpiece
•
the saw blade guard
•
the riving knife
•
the workpiece downholder
•
the table insert
•
•
push stick when cutting small workpieces
•
(distance between saw blade and fence <120mm)
N O TI C E
After the working process the machine must be turned off:
OPERATION
56
TS200 | TS250
Publicidad
