Carel humiSteam Serie Manual Del Usuario página 67

code displayed
controller remote causes
term.*
P H
6 slow E101 internal memory error
flashes
CAREL
or 4 fast
flashes
red
LED
Not E112 error in the parameters user
featured
Not E130 hour counter error
featured
not E120 room probe not connected
featured
not E123 outlet probe not connected
featured
not E132 cylinder being depleted signal
featured
2 slow E133 cylinder depleted signal
flashes cylinder
red LED
9 slow E134 cylinder full with machine off
flashes signal
red LED
not - cleaning cylinder started signal
featured
not E135 timeout signal (see parameter
envisaged "bb") for maintenance
exceeded
not E136 reached final limit (1.5xbb)
envisaged of cylinder operating life
not - complete draining of the
envisaged cylinder activated
not - complete draining for
envisaged extended inactivity
not - complete periodical
envisaged draining active
not - anti-foam algorithm
envisaged active
* CAREL Humivisor (H or T)
** it is recommended to replace the cylinder first
Note:
for the P controllers the alarms cannot be reset. If the alarm is no longer active, it can only be reset by switching the machine off.
solution
1. reset the default parameters
(see Chap. 7.5)
2. if the problem persists, contact the CAREL down
service centre
1. with the machine off check that there
are no defective electrical connections
or faults, then reprogram the parameters
2. reset the default parameters
(see Chap. 7.5)
3. if the problem persists, contact the CAREL
service centre
with the machine off check that there are
no defective electrical connections or
faults, then reset the hour counter
(see par. 7.6)
check the connection of the probe,
parameter A2 for the room probe and the
setting of parameter A0 (see chap. 7)
check the connection of the probe,
parameter A6 for the outlet probe and the
setting of parameter A0 (see chap. 7)
perform maintenance and/or replace the
cylinder
perform maintenance and/or replace the
only
with the machine off:
1. check for any leaks from the fill
electrovalve or the condensate return
pipe
2. check that the level sensors are clean
total shut-down
see paragraph 6.2.1
perform maintenance and/or replace
the cylinder
replace the cylinder
see paragraph 6.3.2.6
see paragraph 11.4.5
see paragraph 11.4.9
see paragraph 11.4.3
67
action reset
display (H)
P H
total machine reprog.
shut- disabled by CAREL
- machine reprog.
disabled params.
- hour reset
counter manual
saving hour
disabled counter
- machine manual
disabled
- signal manual
only
- signal manual
only
signal signal not
only available
total machine manual
shut- disabled
down
- - -
- signal manual
only reset
hour
counter **
- disable manual
unit reset
hour
counter **
- - -
- - -
- - -
- - -
humiSteam - cod. +030221914 rel. 5.2 - 07.11.2005
alarm reset
relay relay (H)
active reprog.
by
active reprog.
params.
not -
active
active auto
active auto
not auto
active
not -
active
active manual
- -
active after the
manual
reset
hour
counter
active after the
manual
reset
hour
counter
- -
- -
- -
- -
Table. 10.3.1