Angelo Po 0N1FR1I Manual De Uso página 158

ENGLISH
INSTRUCTIONS AND WARNING FOR REPLACING PARTS
NOTE: Read the following section of
the "user instruction manual" carefully be-
fore replacing any part:
– Hazards and safety provisions during instal-
lation and commissioning, adjustments and
part replacement.
WARNING: Before making any type
of adjustment, activate all the safety de-
vices provided and decide whether staff at
work and those in the vicinity should be in-
formed. In particular, close the the gas and
water supply taps, cut off the electricity sup-
ply using the master switch and prevent ac-
cess to all devices which might cause un-
expected hazards and damage to people's
health and safety if activated.
To carry out this operation, proceed as follows.
Turn off the gas supply tap.
1)
Open the hatch (A).
2)
Unscrew the nozzle (B) and replace it with
3)
the one suitable for the type of gas in use
(see table at back of manual).
Close the hatch (A).
4)
16
REPLACING PARTS
REPLACEMENT OF THE BURNER NOZZLE
Also make sure that during the maintenance
procedure, that the operator is always able to
check whether the plug is disconnected from
the power outlet. If worn parts have to be
replaced, use original spare parts only. The
manufacturer declines all responsibly for in-
jury or damage to components due to the use
of non original parts, or extraordinary work
on the appliance which may modify the safe-
ty requirements without the manufacturer's
authorisation. When ordering components,
follow the instructions provided in the parts
catalogue.
A
REPLACING PARTS
B
B
3269860_inst_GB_rev.2