SICE FIT LINE 32 Manual De Instrucciones página 80

9. Crushing Hazard. Moving Parts Present. Contact with moving
parts could result in an accident.
• Only one operator may work with the machine at a time.
• Keep all bystanders clear of the tyre changer.
• Keep hands and fingers clear of rim edge during the demounting
and mounting process.
• Keep hands and fingers clear of the mount/demount head during
operation.
• Keep hands and other body parts away from moving parts.
• Do not use tools other than those supplied with the tyre changer.
• Use proper tyre lubricant to prevent tyre binding.
10. Electric Shock Hazard.
• Never hose down or power wash electric tyre changers.
• Do not operate the machine with a damaged power cord
• If an extension cord is necessary, a cord with a current rating equal
to or greater than that of the machine must be used. Cords rated
for less current than the machine can overheat, resulting in a fire.
• Care should be taken to arrange the cord so that it will not be
tripped over or pulled.
11. Risk of Eye Injury. Flying debris, dirt and fluids may be discharged
during bead seating and the inflation process. Remove any debris
from the tyre tread and wheel surfaces. Wear OSHA, CE or other
approved safety glasses during mount and demount procedures.
12. Always inspect the machine carefully before using it. Missing,
broken, or worn equipment (including warning stickers) must be repaired or replaced
prior to operation.
13. Never leave nuts, bolts, tools or other equipment on the machine. They may become
trapped between moving parts and cause a malfunction.
14. NEVER install or inflate tyres that are cut, damaged, rotten or worn. NEVER install a
tyre on a cracked, bent, rusted, worn, deformed or damaged rim.
15. If a tyre becomes damaged during the mounting process, do not attempt to finish
mounting. Remove from the service area and properly mark the tyre as damaged.
16. To inflate tyres, use short bursts while carefully monitoring the pressure, tyre, rim and
bead. NEVER exceed the tyre manufacturer's pressure limits.
17. This equipment has internal arcing or sparking parts which should not be exposed
to flammable vapours (gasoline, paint thinners, solvents, etc.). This machine should not
be located in a recessed area or below floor level.
FITLINE 32 - 32 2V - 32 GP - 32 GP 2V
80 User Manual