Air Pressures; Special Rim/Tyre Considerations - SICE FIT LINE 32 Manual De Instrucciones

1.2.e. AIR PRESSURES
The machine is equipped with an internal pressure limiting valve to minimize the risk of
over inflating the tyre.
1. Never exceed these pressure limitations:
• Supply line pressure (from compressor)
is 220 psi (15 bar).
• Operating pressure (gauge on regulator)
is 145 psi (10 bar).
Bead setting pressure (gauge on hose) is
the tyre manufacturer's maximum pres-
sure as stated on the sidewall of the tyre
2. Activate air inflation jets only when sealing the bead.
3. Bleed air pressure system before disconnecting supply line or other pneumatic com-
ponents. Air is stored in a reservoir for operation of inflation jets.
4. Only activate the air inflation jets if the rim securing device is locked in place and
the tyre is properly clamped (when possible).

1.3. SPECIAL RIM/TYRE CONSIDERATIONS

Wheels equipped with low tyre pressure sensors or special tyre and rim designs
may require special procedures. Consult wheels and tyre manufacturers' service
manuals.
90
DANGER
• EXPLOSION HAZARD
• Never exceed the tyre pressure recommended by the tyre
manufacturer. Never mismatch tyre size and rim size.
• Avoid personal injury or death
NOTICE
User Manual
FITLINE 32 - 32 2V - 32 GP - 32 GP 2V