Publicidad
Idiomas disponibles
Idiomas disponibles
HOLZMANN Maschinen GmbH
NOTE:
Position A: for straight cuts
Position B: for angle cuts
-
-
-
-
-
-
-
-
www.holzmann-maschinen.at
3. Rip fence
- Mount the ruler (1) and rip fence guide (2) as
shown
- Adjust parallelism with screws and nuts (3)
- Disassemble the end stop (4)
- Set clamping lever (5) to position not fixed and
slide the fence bracket (6) on the fence guide.
- Remount the end stop
- Slide the rip fence (7) on the guidance of the
bracket.
2 possible positions.
- Fix the rip fence with the clamping lever (8) on
desired position
- Mount the holder with the push stick (9)
- Mount the dirt wiper (10) as shown
4.
Outrigger table
- Push the groove stone of the outrigger table (1)
into the groove of the sliding table.
- Place the holder of the outrigger table on the
swivel arm support (2).
- Tighten the clamping levers (3) of the outrigger
table to fix the position.
- Adjust the horizontal alignment with the
adjusting screws (4).
- Insert the pivot mount of the crosscut fence (5)
into the front or rear hole of the outrigger table
and fix it with clamping 90° (6)
- Insert the groove stone of the support fixing into
the opening, push the groove stone into the
groove of the support (7) and fix it in the desired
position with the fixing screw (8).
- Push the flip stops (9) into the groove of the cross
cut fence
- Fix the magnifiers (10) with screws
- Secure the crosscut fence in desired angle
position with clamping screw (11)
5.
Saw blade
Adjust the cutting height to the maximum
possible level.
Push the sliding table all the way foreward.
Open the saw blade guard.
Fix the drive shaft with the supplied Allen key (5)
and loosen the flange nut (4) with the saw blade
wrench (6) (left-hand thread!)
Remove flange nut (4) and flange (3)
Place the well cleaned shaft flange (1), saw blade
(2), flange (3) and flange nut (4) on the drive shaft
Fix the drive shaft with the supplied Allen key (5).
Tighten the flange nut with the saw blade wrench
(6) (left-hand thread!)
NOTE:
min. tightening torque: 50Nm
- Close the saw blade guard.
ASSEMBLY
40
FKS305V32TOP_400V
Publicidad
