Holzmann FKS305V32TOP 400V Instrucciones De Servicio página 52

16.4 Disposal
Observe the national waste disposal regulations. Never dispose of the
machine, machine components or operating equipment in the residual waste.
If necessary, contact your local authorities for information regarding available
disposal options.
If you purchase a new machine or equivalent equipment from your specialist
dealer, he is obliged in certain countries to dispose of your old machine
properly.
TROUBLESHOOTING
Danger due to electrical voltage!
Handling the machine with connected power supply may result in serious injury or
death.
 Disconnect the machine from the power supply before starting work to
eliminate defects!
Many possible sources of error can be eliminated in advance if the machine is properly connected
to the power supply.
If you are unable to carry out the necessary repairs properly and/or do not have the required
training, always consult a specialist to solve the problem.
Trouble
Motor does not run
Burn marks on the
workpiece
Finished dimension of the
workpiece does not
correspond to the cutting
width set on the rip fence
Workpiece clamps when
being pushed forward
Loud, repetitive noises from
the machine
Machine slows down
during operation
Saw blade is not square or
fence is not square to saw
blade
Scoring blade does not
start
HOLZMANN Maschinen GmbH
WAR N I N G
Possible cause
• Switch defective
• Saw blade guard not
completely closed – limit
switch
• Electrical system defective
• Emergency stop is
activated
• Blunt saw blade
• Dimension scale for the
cutting width misaligned
• Blunt saw blade
• Riving knife does not
match to the saw blade
used
• Set screws or keys are loose
• Motor fan hits cover
• V-belt defective
• Too much pressure to the
workpiece
• Loose V-belt
• Table top or fence are not
aligned parallel
• Main saw blade is not
started
• V-belt defective
www.holzmann-maschinen.at
TROUBLESHOOTING
Solution
• Repair switch
• Close the saw blade guard well so that
the limit switch is activated
• Check main cable, plug and motor;
repair or replace, if necessary
• Check fuse
• Deactivate the emergency stop
• Change saw blade
• Reset the zero point of the rip fence
• Change saw blade
• Riving knife thickness must be equal to
or greater than saw blade thickness
• Tighten or replace set screws or keys
• Tighten motor fan and cover
• Replace V-belt
• Feed the workpiece more slowly
• Tension V-belt
• Align table parallel to saw blade
• Start main saw blade
• Check V-belt and change if necessary
52
FKS305V32TOP_400V