Publicidad
Idiomas disponibles
Idiomas disponibles
14.3
Electrical connection
Dangerous electrical voltage!
The machine may only be connected to the mains supply and the associated
checks carried out by a qualified electrician or under the instruction and
supervision of a qualified electrician!
Check, whether the neutral connection (if existing)and the protective grounding function
•
properly.
Check, whether the supply voltage and the frequency correspond to the specifications of
•
the machine.
HOLZMANN Maschinen GmbH
-
-
-
-
-
-
-
-
WAR N I N G
www.holzmann-maschinen.at
6.
Scoring saw blade
Adjust the cutting height to the maximum
possible level
Push the sliding table all the way foreward.
Open the saw blade guard
Fix the drive shaft with the supplied Allen screw
(6) and loosen the flange nut (4) with the wrench
(6) (right-hand thread!)
Remove flange nut (4) and flange (3)
Place the well cleaned shaft flange (1), saw blade
(2), flange (3) and flange nut (4) on the drive shaft
Fix the drive shaft with the supplied Allen screw
(6).
Tighten the flange nut with the saw blade wrench
(5) (right-hand thread!)
NOTE:
min. tightening torque: 25Nm
- Close the saw blade guard.
7.
Saw blade guard
- Fix the saw blade guard (1) to the riving knife (3)
with the locking screw (2).
NOTE:
The saw blade guard should be positioned as
close as possible to the workpiece.
8.
Edging shoe
- Insert the edging shoe (1) into the groove of the
sliding table and fix it in the desired position with
star screw (2).
9.
Mitre gauge
- Insert the mitre gauge (3) into the groove of the
sliding table and fix it in the desired position with
the knurled screw (4).
ASSEMBLY
41
FKS305V32TOP_400V
Publicidad
