Publicidad
Idiomas disponibles
Idiomas disponibles
Saw blade speed
Lock of sliding table
OPERATION
Only operate the machine when it is in a perfect condition. Before each operation, a visual
inspection of the machine must be carried out. Safety devices, electrical cables and operating
elements must be checked carefully. Check screw connections for damage and tight fit.
15.1
Operating instructions
•
Make sure that the saw blade used matches the set speed of the machine and that the
diameter of the saw blade is compatible with the machine.
•
Cracked and deformed saw blades cannot be repaired. They must be replaced
immediately with new saw blades.
Make sure that the machine works without vibrations.
•
Always use the riving knife and the saw blade guard. Make sure that the riving knife, the
•
saw blade guard and the height of the saw blade are positioned correctly. The riving knife
must always be aligned with the workpiece. Otherwise there is a risk that the workpiece
will stick and cause kickback.
•
Make sure that the workpiece is in a stable position on the table and is supported by either
the rip fence or the outrigger table during cutting.
•
Make sure that the work table and the sliding table are parallel to the saw blade.
Never stand in the direct cutting line of the saw blade, do not hold any parts of your body
•
in the cutting line. Keep the side of the saw blade whenever cutting.
Never reach over or behind the saw blade with your hand while cutting.
•
Avoid awkward operations and hand positions where a sudden slip could cause your hand
•
to get caught in the rotating saw blade.
When using the cross-cut fence, the workpiece should not touch the rip fence at the same
•
time as cutting.
Use the push stick if the distance between the saw blade and the ruler of the rip fence is
•
less than 120 mm.
Use the downholder to secure the workpiece.
•
•
Guide the workpiece smoothly until the end of cutting.
Avoid jerky movements and changing direction.
•
HOLZMANN Maschinen GmbH
Position I: see techn. data
Position II: see techn. data
The sliding table is secured against accidental
movement. To loosen the locking, pull the lever out of
the fixation and turn it for appr. 90°.
www.holzmann-maschinen.at
- Open the maintenance door
- Insert Allen key into motor tensioning screw (1),
push tensioner to the left to release belt tension
- Position drive belt (2) on corresponding motor
belt pulley (3) and drive belt pulley (4)
- Push the motor tensioner back to the right
- Check belt tension and adjust if necessary
- Close the maintenance door
OPERATION
45
FKS305V32TOP_400V
Publicidad
