Publicidad
Idiomas disponibles
Idiomas disponibles
Assembly / exchange / adjustments scoring saw blade
Checking / adjusting / replacing belt
For optimum power transmission, the belt must be free of cracks and frays and have optimum
tension. Check the condition of the belt at least every 3 months, more frequently if used daily.
Broken or frayed belts must be replaced. To check/adjust or replace the belt, open the
maintenance door.
HOLZMANN Maschinen GmbH
• Adjust the cutting height to the maximum possible
• Set the saw blade to 90°.
• Push the sliding table all the way foreward.
• Open the saw blade guard (7).
• Fix the drive shaft with the supplied Allen key (6).
• Loosen the flange nut (4) with the saw blade
• Remove flange nut (4), flange (3) and scoring saw
• Clean the drive shaft, the shaft flange (1) and all
• Replace the old scoring saw blade with a new one.
• Make sure that the new scoring saw blade is
• Place the scoring saw blade (2), flange (3) and
• Fix the drive shaft with the supplied Allen key (6).
• Tighten the flange nut with the saw blade wrench
• Close the saw blade guard.
• Bring the sliding table back into position.
NOTE:
adjusted so that it cuts a slot of a depth of 1.5 - 2mm.
The scoring saw blade has to be oriented exactly to the
main saw blade
Adjustments:
•
www.holzmann-maschinen.at
CLEANING, MAINTENANCE, STORAGE, DISPOSAL
level.
wrench (5) (right-hand thread!)
blade (2) from the drive shaft.
parts thoroughly from impurities
undamaged and not dirty.
flange nut (4) on the drive shaft.
(5) (right-hand thread!)
NOTE:
Retighten the flangenut tightly to prevent the
nut from loosening during operation.
(tightening torque: 25Nm)
The height of the scoring blade must be
Adjust main saw blade to 90°
Heihght of the scoring saw blade (1)
-
Turning the setting wheel (2) to the left .
-
Turning the setting wheel (2) to the right .
Lateral adjustment oft he scoring saw blade(1)
-
Turning the setting wheel (3) to the left
-
Turning the setting wheel (3) to the right
.
.
50
FKS305V32TOP_400V
Publicidad
