Publicidad
Idiomas disponibles
Idiomas disponibles
Use only original spare parts recommended by the manufacturer.
•
•
Repair work may only be carried out by qualified personnel.
Maintenance plan
The type and degree of machine wear depends to a large extent on the operating conditions. The
following intervals apply when the machine is used within the technical limits:
Interval
Before usage
Once a week
Once a month
If necessary
Assembly / exchange saw blade
Adjust the riving knife and the saw blade guard after each saw blade change.
HOLZMANN Maschinen GmbH
Components
• Machine
• Loose fixing bolts, screws
• Control panel
• Guide track and roller guide of
sliding table and rip fence
• Moving parts
• Maintenance room
• Saw blade, scoring saw blade
• V-belt
• Adjust the cutting height to the maximum possible
• Set the saw blade to 90°.
• Push the sliding table all the way foreward.
• Open the saw blade guard (7).
• Fix the drive shaft with an Allen key (5).
• Loosen the flange nut (4) with the saw blade wrench
• Remove flange nut (4), flange (3) and saw blade (2)
• Clean the drive shaft, shaft flange (1) and all parts
• Replace the old saw blade with a new one.
• Make sure that the new saw blade is undamaged
• Place the saw blade (2), flange (3) and flange nut (4)
• Fix the drive shaft with an Allen key (5).
• Tighten the flange nut with the saw blade wrench (6)
NOTE:
nut from loosening during operation.
(tightening torque: 50Nm)
• Close the saw blade guard.
• Bring the sliding table back into position.
www.holzmann-maschinen.at
CLEANING, MAINTENANCE, STORAGE, DISPOSAL
• Clean
• Check for tight fit, tighten if necessary
• Check for function, replace if necessary
• Clean, blow out
• Lubricate
• Vacuum chips
• Clean the motor housing
• Change
• Change
level.
(6) (left-hand thread!)
from the drive shaft.
thoroughly from impurities
and not dirty.
on the drive shaft.
(left-hand thread!)
Retighten the flangenut tightly to prevent the
N O TE
Action
FKS305V32TOP_400V
49
Publicidad
