Flex FX7221 Manual Del Operador página 16

REMOVE CABLE TIE AND STYROFOAM
BLOCK (FIG. 2)
(Used for shipping purpose only)
With the table surface on the ground, locate the
cable tie that anchors the motor/blade assembly
to the base. Using scissors or wire cutters, cut and
remove the cable tie.
Release the bevel lock handle, tilt the blade to 45
degrees, then remove styrofoam block located
between the motor housing and the table.
INTENDED USE
WARNING
This table saw is intended for rip, cross, miter,
bevel, and non-through cut applications in
various wood and plastic materials.
Avoid overheating the saw
blade tips.
Fig. 2
If cutting plastic, make sure the feed rate is
slow enough and blade tips are sharp enough
to avoid melting the plastic.
Do not use this table saw for cutting metals,
such as aluminum or copper, or any masonry or
cement materials.
-16-
Remove
Styrofoam Block
Remove
Cable Tie