Flex FX7221 Manual Del Operador página 23

TO ATTACH THE RIP FENCE (FIG. 8)
Ensure that the rip fence lock levers on both
sides of the fence are in the released position.
Align the notch on the rip fence bracket with one
of the 3 index bolts on the front and rear rails.
Ensure that the flip-over fence is in its stored
position, facing away from the blade (Fig. 8).
Press the lock levers down to secure the rip
fence in place.
Miter gauge storage (Fig. 9a)
When not in use, store the miter gauge under
the back side of the table.
Insert the front end of the miter gauge into the
miter gauge storage slot located on the saw's
rear foot.
To remove the miter gauge, just pull it out.
Push stick storage (Fig. 9b)
When not in use, insert the push stick into the
push stick holder.
Rip fence storage (Fig. 9c-9d)
When not in use, store the rip fence under the
left end of the table on the rails. Remove the
fence from its in-use position on the rails.
a. Ensure that the flip-over fence, in its stored
position (Fig. 9c).
b. On the left side of the saw, hold the rip fence
upside down under the rails. Latch both of
the rip fence lock levers (Fig. 9d).
STORAGE AND TRANSPORTATION
Fig. 8
Fig. 9a
Fig. 9b
Fig. 9c
-23-
Rip Fence
Flip-over
Fence
Rip Fence
Lock Lever
Notch
Index Bolt
Miter Gauge
Push Stick
Flip-over
Fence