Flex FX7221 Manual Del Operador página 26

Mounting the table saw to a stand (Fig. 9l)
Follow operator's manual included with FLEX
folding table saw stand model FT721 (sold
separately) to assembling the stand and
installing the table saw onto the stand.
ADJUSTING 0 AND 45 DEGREE POSITIVE
STOPS (FIG. 10a-10c)
Your saw is equipped with positive stops for fast
and accurate positioning of the saw blade at 90
and 45 degrees to the table.
WARNING
battery pack from the tool when making
adjustments.
Adjusting 0 degree position stop
a. Turn the elevation wheel clockwise and raise
the blade to its maximum height.
b. Loosen the bevel lock handle and push the
elevation wheel to the left as far as possible,
then tighten the bevel lock handle (Fig. 10a).
c. Place a combination square on the table
with one end of the square against the blade
as shown (Fig. 10b), and check to see if the
blade is 90 degrees to the table. If the blade
is not 90 degrees to the table, loosen the
bevel lock handle, loosen the 90° cam screw
with Phillips screwdriver (not supplied) and
push the elevation wheel until the blade is 90
degrees to the table.
d. Tighten the bevel lock handle, rotate the 90°
bevel stop cam until it touches the bevel stop
housing, then tighten the 90° cam screw.
e. Loosen the pointer screw and adjust the
pointer to indicate at 0 degrees on the bevel
scale.
ADJUSTMENTS
To prevent personal injury,
always disconnect the
Fig. 9l
Fig. 10a
90º Bevel
Stop Cam
Fig. 10b
-26-
45º Cam Screw
Pointer
45º Bevel Stop Cam
Bevel Lock Handle
Elevation Wheel
90º Cam Screw