Flex FX7221 Manual Del Operador página 49

SHARPEN THE TEETH OF THE ANTI-
KICKBACK DEVICE (FIG. 42)
Make sure the teeth of the pawls of the anti-
kickback device are always sharp. To sharpen:
Remove the anti-kickback device.
•
Rotate one pawl away from the other.
•
Hold the pawl over corner of a workbench.
•
Use a small, round file (smooth cut) to sharpen
•
the teeth.
RAIL LOCK ADJUSTMENT (FIG. 43)
a. Loosen the rail locking lever.
b. On the underside of the saw, loosen the jam
nuts.
c. Tighten the hex rod until the spring on the
locking system is compressed, (not fully
compressed) creating the desired tension on
the rail locking lever. Retighten the jam nuts
against the hex rod.
d. Check that the fence does not move when
the locking lever is engaged. If the fence is
still loose, tighten the spring further.
Cleaning
The tool may be cleaned most effectively with
compressed dry air.
WARNING
tools with compressed air. Ventilation
openings and switch levers must be kept clean
and free of foreign matter. Do not attempt to
clean by inserting pointed objects through
openings.
Always wear safety
goggles when cleaning
Fig. 42
Fig. 43
WARNING
plastic parts. Some of these are: gasoline,
carbon tetrachloride, chlorinated cleaning
solvents, ammonia and household detergents
that contain ammonia.
Store the tool indoors in a place that is
inaccessible to children. Keep away from
corrosive agents.
-49-
Hex Rod
Jam Nut
Certain cleaning agents
and solvents damage
Storage