Flex FX7221 Manual Del Operador página 38

MAKING A FEATHERBOARD
Figure 26 illustrates dimensions for making a
typical featherboard. It should be made from a
straight piece of wood that is free of knots or
cracks. Kerf E should be 1/4" wide.
USING THE FLIP-OVER FENCE
When the rip fence is beyond the table-top,
ensure that the flip-over fence is secured in the
lowest position in both the front and the back
slots. When the rip fence is over the table,
ensure that the flip-over fence is in the upper
position on both the front and back slots
(Fig. 27a&27b).
If an auxiliary fence is required, place the flip-
over fence in the stored position on both the
front and back slots.
Fig. 26
3/4
NOTE: All dimensions in inches.
Fig. 27a
Fig. 27b
-38-
25
5
4-1/2
8
E