Flex FX7221 Manual Del Operador página 27

Adjusting 45 degree positive stop
a. Turn the elevation wheel clockwise and raise
the blade to its maximum height.
b. Loosen the bevel lock handle and push the
elevation wheel to the right as far as possible,
then tighten the bevel lock handle.
c. Place a combination square on the table
with one end of the square against the blade
as shown (Fig. 10c), and check to see if the
blade is 45 degrees to the table. If the blade
is not 45 degrees to the table, loosen the
bevel lock handle, loosen the 45° cam screw
with Phillips screwdriver (not supplied) and
push the elevation wheel until the blade is 45
degrees to the table.
ADJUST THE BLADE PARALLEL TO THE
MITER GAUGE SLOTS (FIG. 11a-11c)
The blade was adjusted parallel to the miter
gauge slots at the factory. In order to ensure
accurate cuts and help prevent kickback, this
adjustment should be rechecked. If adjustment
is necessary, follow the steps below.
WARNING
battery pack from the tool when making
adjustments.
WARNING
beveling side of the saw blade.
a. Turn elevation wheel and raise blade as high
as it will go.
b. Select a point on the body of the saw blade
that is set to the left when viewing the blade
from the front of saw, and mark with a pencil.
c. Place the base of a combination square
against the edge of the miter gauge slot, and
extend the sliding rule of the square so it just
touches the marked point on the body of the
saw blade at the rear of the table, avoiding
the blade teeth (Fig. 11a).
d. Rotate the blade and check the same marked
point of the saw blade at the front of the
table.
To prevent personal injury,
always disconnect the
To prevent personal injury,
avoid bevel ripping on
Fig. 10c
d. Tighten the bevel lock handle, rotate the 45°
bevel stop cam until it touches the bevel stop
housing, then tighten the 45° cam screw.
Fig. 11a
Fig. 11b
Under the front of the table
Alignment Bolts
Under the rear of the table
-27-
Mark