Flex FX7221 Manual Del Operador página 29

c. Move the rails so that the position indicator
lines up with "0" on the top scale. Lock the
rails in place using the rail locking lever. If
anti-kickback device is installed, you will need
to raise the right side in order to align the
fence with the blade.
d. Slide the fence along with the front and back
index bolts towards the blade until the fence
touches the blade teeth at the front and back
of the blade.
e. Tighten the front index bolt 1. Verify that the
fence is still in contact with the front and back
teeth of the blade.
f. Tighten the back index bolt 1. Verify that the
fence is still in contact with the front and back
teeth of the blade.
g. Secure the rip fence lock levers and ensure
that the fence is still in contact with the front
and back teeth of the blade.
Adjust the right side, position 2 (further from
blade). See Fig. 12c
NOTE: The right side position 2 for the fence
permits cuts of 6 to 30.5 inches on the right side of
the blade. The bottom scale shows this dimension.
In this location, the flip-over fence should be on
the left of the main fence when in the material
support position (closest to the blade).
a. Release the rip fence lock levers and remove
the fence.
b. Use the included 5 mm Allen key to loosen
the right index bolts 2 on the front and back
rails, approximately 1/2 to 1 turn so that the
bolts can slide freely.
c. Place the fence alignment holes in the blade
wrench over the right index bolt 1 on the
front rail (already fixed in place as described
in chapter "Adjust the right side, position 1
(close to blade)" above) with the second hole
roughly aligned with the right index bolt 2.
d. Move the right index bolt 2 until the blade
wrench slides over the bolt head.
e. Tighten the right index bolt 2.
f. Perform steps "c" through "e" to adjust the
right index bolt 2 on the back rail.
Adjust the left side position. See Fig. 12b
NOTE: The left side position for the fence
permits cutting of 0 to 16.5 inches on the left
side of the blade. The scale does not show this
dimension. In this location, the flip-over fence
should be on the right of the main fence when in
Fig. 12b
Left Index Bolt
Fig. 12c
Right Index Bolt 1
the material support or auxiliary fence position
(closest to the blade).
a. Use the included 5 mm Allen key to loosen
the left index bolts on the front and back
rails, approximately 1/2 to 1 turn so that the
bolts slide freely. Move the bolts so they are
approximately 3.5 inches (89 mm) from the
left end of the rails.
b. Place the fence over the left index bolts but
do not secure the rip fence lock levers on the
front or back rail.
c. Move rails so that the fence touches at least
one tooth on the blade. Lock the rails in place
using the rail locking lever. If anti-kickback
device is installed, you will need to raise the left
side in order to align the fence with the blade.
d. Slide the fence along with the front and back
index bolts towards the blade until the fence
touches the blade teeth at the front and back
of the blade.
e. Tighten the front left index bolt. Verify that the
fence is still in contact with the front and back
teeth of the blade.
f. Tighten the back left index bolt. Verify that the
fence is still in contact with the front and back
teeth of the blade.
-29-
Right Index Bolt 2
Rail Locking
Lever
Right Index Bolt 1
Right Index Bolt 2
Blade Wrench