Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING
personnel may result in misplacing of
internal wires and components which could
cause a serious hazard. We recommend that
all tool service be performed by a FLEX Factory
Service Center or Authorized FLEX Service
Station.
General Maintenance
WARNING
parts. Use of any other parts could create a
hazard or cause product damage. Periodically
inspect the entire product for damaged,
missing, or loose parts such as screws, nuts,
bolts, caps, etc. Tighten securely all fasteners
and caps and do not operate this product until
all missing or damaged parts are replaced.
Please contact customer service or an
authorized service center for assistance.
TOOL LUBRICATION (FIG. 41)
The gear case has been completely lubricated
at the factory. However, after six months to one
year, depending upon use, it is wise to return
your tool to the nearest Service Center for the
following:
Brushes replaced.
•
Parts cleaned and inspected.
•
Relubricated with fresh lubricant.
•
Electrical system tested.
•
All repairs.
•
The following parts should be oiled occasionally
with SAE No. 20 or No. 30 oil, or WD 40.
Elevation, support rods, and gears.
•
Sliding rails and supports.
•
MAINTENANCE
Service
Preventive maintenance
performed by unauthorized
When servicing, use only
identical replacement
WARNING
battery pack from the charger/tool when
cleaning or performing any maintenance.
CARE OF BLADES
Blades become dull even from cutting
regular lumber. If you find yourself forcing
the saw forward to cut instead of just
guiding it through the cut, chances are the
blade is dull or coated with wood pitch.
When cleaning gum and wood pitch from
the blade, disconnect the battery pack and
remove the blade. Remember, blades are
designed to cut, so handle carefully. Wipe
the blade with gum and pitch remover or
similar solvent to remove the gum and pitch.
Unless you are experienced in sharpening
blades, we recommend you do not try.
Fig. 41
Elevation
Gears
Periodically lubricate moving parts, such as the
elevation gears, with a silicone or light oil spray.
Do not use grease because it tends to attract
and hold sawdust.
-48-
To avoid serious personal
injury, always remove the
Publicidad
