Flex FX7221 Manual Del Operador página 19

The power adaptor features wall-mount holes for
convenient use. Install screws in the wall 2-1/8
inches (54 mm) apart. Use screws sufficiently
strong to hold the weight of the power supply
(Fig. 3d).
TO REMOVE AND INSTALL THE TABLE
INSERT (FIG. 4a-4b)
WARNING
table insert must be locked in place at all
times.
WARNING
performing any assembly or adjustments, or
changing accessories. Such preventive safety
measures reduce the risk of starting the tool
accidentally.
To remove table insert (Fig. 4a)
Place your index finger into the finger hole to lift
and pull the table insert out toward the front of
the saw.
To install table insert (Fig. 4b)
Position the table insert tabs into the pockets
and place the table insert down. Make sure the
table insert is seated properly and securely in
place.
The table insert is adjustable and,
NOTICE
therefore, can change over time.
Verify that the table insert is set correctly before
every use. If adjustment is needed, follow the
instructions in chapter "ADJUSTING THE
TABLE INSERT".
To reduce the risk of
serious personal injury, the
Detach the battery pack
from the tool before
Fig. 3d
Wall-mount
Holes
Fig. 4a
Finger Hole
Fig. 4b
-19-
Table Insert
Table Insert
Tabs