Mx Onda MX-VC2650 Manual De Usuario E Instalacion página 35

USING TOUCH CONTROLS
•
Controls respond to touch, so no pressure is necessary.
•
Use the entire tip of your finger, not the tip. You will hear a beep each time a
touch is detected.
•
Make sure that the controls are always clean, dry, and that no object (for
example, a utensil or cloth) is covering them. Even a thin layer of water can
make the controls difficult to operate.
USE OF THE VITROCERAMIC PLATE
To start cooking
4.
After connecting the board to electricity and turning it on.
Press and hold the ON/OFF control button for about 3 seconds
until you hear a "beep" to turn on the plate on. Now the plate
goes into Standby mode, all the heat.
The setting indicators and timer setting indicators show "-"
5.
Place a container suitable for the chosen cooking zone.
• Make sure the bottom of the container and
the surface of the cooking zone are clean
and dry.
6. Set the heating level of the cooking zone.
A Before adjusting the heat level, it is necessary to touch the
Heating zone selection control button to select and activate the cooking
zone you want to use. Heat Settings
The selected zone indicator flashes when it is active, then you could adjust its
heat level lower:
Adjust the heat setting by sliding the slider.
•
10