Mx Onda MX-VC2650 Manual De Usuario E Instalacion página 48

CONNECTION OF THE VITROCERAMIC PLATE TO THE ELECTRICAL
MAINS
The ceramic hob must be installed by a licensed electrician or a suitably
qualified technician.
Before connecting the ceramic hob to the mains, check that:
1. The electrical installation where you are going to connect the glass-ceramic
plate must be suitable for the power consumed by the glass-ceramic plate.
2. The voltage must correspond to the nominal value specified in the
characteristics described in this manual.
3. The section of the power cables must withstand the current specified on the
rating plate.
To connect the ceramic hob to the mains outlet, you should not use adapters,
reducers or splitters, as these devices can heat up and cause a fire.
The power cable of the ceramic hob must not touch any part or area where it
acquires high temperatures and must be placed so that the temperature will not
exceed 75ºC at any point.
1. If the cable is damaged or needs to be replaced, this must be done by an
after-sales technician using the appropriate tools, to avoid accidents.
2. If the appliance is connected directly to the mains, an omnipolar circuit
breaker must be installed with a minimum gap of 3 mm between the contacts.
3. The installer must ensure that the correct electrical connection has been
made and that it complies with safety regulations.
4. The cable must not be bent or compressed.
5. The cable should be checked periodically and replaced only by a qualified
technician.
Check with a licensed and qualified electrician for proper electrical installation.
Any modification to the electrical installation must be carried out only by a
licensed electrician.
The electrical connection of the ceramic hob must be made in accordance with
current regulations and protected by a single-pole magneto-thermal or
automatic switch. The connection is shown below:
23