Mute Feature; Cleaning And Maintenance - Zavor LUX EDGE Manual Del Usuario

recipe calls for 12 minutes of high pressure cooking. First press the pressure
cook function once and then adjusting the time with the + button until it reads
00:12 minutes and then press the Time Delay button once and then the + button
until the panel reads 06:00 hours. Next, you press the START/STOP button, and
you're all set! The cooker will start cooking at 5:30 p.m.

Mute Feature

If you would like to disable all the beeps from the multi-cooker, you may do so
by pressing and holding the + and - buttons simultaneously until the display
shows the word MUTE. All beeps, including button presses and unit notification
sounds, become disabled for the duration of the use.
To unmute the multi-cooker, press and hold the + and - buttons simultaneously
until the display shows the word BEEP and then the unit produces two beeps to
unmute all beeps.
NOTE: If you mute the multi-cooker and then unplug it after use, this disables
the mute feature, and the unit becomes unmuted for its next use.

Cleaning and Maintenance

Do not wash any parts of the multi-cooker in the dishwasher except for the
removable cooking pot. Always wash the removable cooking pot thoroughly
after every use, or if it has not been used for an extended period of time.
1. Unplug the multi-cooker and let the unit cool before cleaning.
2. Remove the removable cooking pot and wash with warm soapy water or in
the dishwasher. However, hand washing is always recommended. Rinse and
dry thoroughly.
3. Wipe the outer housing with a clean damp cloth and rinse the lid with warm
water and soap. Do not submerge the multi-cooker or the lid in water.
NOTE: To remove an odor from the inside part of the lid, clean it with water
and vinegar (1:1 ratio).
4. Remove the condensation reservoir by pulling it down. Wash with warm,
soapy water. Rinse and dry thoroughly. Replace by pushing it back into
place.
5. Carefully remove the y-shaped silicone gasket attachment by grasping the
center of the metal "Y" and pulling. Remove the silicone gasket from the
metal ring. Clean the silicone gasket with warm soapy water. Rinse and
dry thoroughly. Place the gasket back on the metal ring and then place the
37