Safety; Explanation Of Symbols; Use As Intended - AHT MACAO Serie Manual De Instrucciones

2 | Safety

statutory provisions applicable at the time of conclusion
of the contract shall apply.
Technical changes and errors reserved.
The local trade and safety regulations/provisions and
fundamental health and safety requirements for the ap-
pliance apply.
2 Safety

2.1 Explanation of symbols

In this manual, safety notices and warnings are indi-
cated by symbols and signal words. Signal words indi-
cate the hazard risk level.
Signal word Meaning
Hazard with medium risk level. May re-
WARNING
sult in serious injury or death if not
averted.
Hazard with low risk level. May result in
CAUTION
minor or moderate injury if not averted.
Important note on preventing material
NOTICE
or property damage.
Symbol Meaning
General warning
Warning: electrical voltage
Warning: electrical voltage. Do not con-
nect damaged cables to the voltage
supply.
Warning: flammable materials
Warning: slip hazard
Warning: hand injuries
Warning: industrial trucks
Warning: tipping hazard
Warning: falling objects
Warning: hot surface
Warning: low temperature/frost
No open flames; fire, open sources of
ignition, and smoking prohibited
Do not enter
Do not set down or store any item
28 / 505
AHT Cooling Systems GmbH | en
Symbol Meaning
Drilling prohibited
Read the manual
Disconnect prior to maintenance or re-
pair
Use hand protection
Use eye protection
Separate collection of electrical and
electronic equipment
Explosion protection symbol

2.2 Use as intended

The appliance is intended for the display of packaged,
deep frozen food products, in particular ice cream, or
access to them by customers.
The operator is responsible for proper operation of the
appliance.
WARNING
Danger due to misuse.
▪
Do not make any technical changes
to the appliance.
▪
Do not use steam or high-pressure
cleaners for basic cleaning.
▪
Do not store explosive materials
such as aerosol containers with com-
bustible propellant gas in this appli-
ance.
▪
Only start up and operate the appli-
ance once it has been properly set
up and installed and has no obvious
defects.
NOTICE
Material and property damage due to misuse.
▪
Do not operate the appliance above the cli-
mate class stated on the rating plate (see →
Rating plate and serial number).
▪
The ambient temperature must not fall below
16°C (60.8°F).
▪
Operate the appliance in a stable operating
position (horizontal alignment).
▪
Check that the appliance is in good, proper
condition. Any damage must be repaired im-
mediately.
▪
Prior to storing goods and during operation,
check to ensure that the temperature is cor-
rect (see → Temperature display).
▪
In the event of a power failure, stored goods
must be checked by the operating company
(temperature check).
405859_1_0819