Setting The Mb Level; Preparation For Diving With Two Gas Mixtures; Preparation For The Dive And Function Check; Functions During The Dive - Scubapro Aladin 2G Manual De Usuario

3. Diving with Aladin 2G
Max Operating
Depth MOD
Change the O % mix by
2
and (–)
3. Change the oxygen fraction in incre-
ments of 1% by pushing
. Aladin 2G will display the current
fraction of oxygen, the maximum partial
pressure limit (ppO
4. Confirm the selected percentage with
.
Change the ppO
5. By pushing
change the ppO
fraction of oxygen down to 1.0bar. Ala-
din 2G will now display the correspond-
ing MOD for the new ppO
6. Confirm your ppO
.
)
NOTE:
• Without confirmation the display will
disappear after 3 minutes and your
entries will not be accepted.
• Automatic reset of the O
21% can be set with "set 1" ->58 or
22
ppO max
2
(+)
or
max) and the MOD.
2
max by (+) and
2
(–)
or you can
max for the chosen
2
max.
2
max settings with
2
% mix to
2
SmartTRAK between 1 and 48 hours
or to "no reset" (default).
3.3.2

Setting the MB level

See chapter 6, ->37
3.3.3 Preparation for diving with
two gas mixtures
See chapter 8, ->48
3.3.4 Preparation for the dive and
function check
Switch on Aladin 2G by pushing
check the test display: Are all elements of
the display activated? Do not use Aladin 2G
if the display does not show all elements.
When switching on Aladin 2G with
the test display will not appear.
WARNING
Check the battery capacity before each dive
->16.
3.4

Functions during the dive

3.4.1 Immersion

If the water contacts are deactivated (->61),
switch on Aladin 2G before immersion.
WARNING
If you have chosen the option "Water contacts
off" ("set 1" or SmartTRAK), Aladin 2G will turn
on with a delay of up to 1 minute into the dive.
This will affect functioning of the computer.
Make sure that the computer is on before
starting the dive.
After immersion, starting at a depth of
about 0.8m (3ft), all diving functions
and
,
SCUBAPRO ALADIN 2G