Scubapro Aladin 2G Manual De Usuario página 147

The change must be made with particular
care in order to prevent water from seeping in.
The warranty does not cover damages due to
an improper replacement of the battery.
Never touch the metal surface of the battery
with bare fingers.
The two battery poles must never be short
circuited.
Procedure:
To replace the battery you need a coin or
the SCUBAPRO universal tool and a clean
cloth.
• A leaking battery cap may lead to the
destruction of Aladin 2G by water seeping
in or cause Aladin 2G to switch off without
prior notice.
• Always open the battery compartment in a
dry and clean environment.
• Only open the battery compartment to
replace the battery.
1. Dry Aladin 2G with a soft towel.
2. Turn the battery cap with a coin or with
the SCUBAPRO universal tool.
3. Remove the battery cap.
4. Remove the O-ring carefully. Do not
damage the sealing surfaces.
5. Remove the battery. Do not touch the
contacts.
SCUBAPRO ALADIN 2G
WARNING
WARNING
SCUBAPRO
universal tool
)
NOTE:
Protect the environment and dispose
the battery properly.
WARNING
If you notice traces of seeping water,
damages, or other defects on the oring, do
not use Aladin 2G for further dives. Take it to
an authorized SCUBAPRO UWATEC dealer for
check and repair.
6. Always insert a new O-ring when you
replace the battery and dispose the old
O-ring. Make sure that the new O-ring
is in perfect condition, and that O-ring,
O-ring groove and the sealing surfaces
are free of dust and dirt. If necessary,
clean the parts with a soft cloth. Fit
the O-ring in the O-ring groove of the
battery cap.
WARNING
7. Use only an original SCUBAPRO O-ring.
This O-ring is Teflon coated and does not
require additional lubrication.
8. Do not lubricate the O-ring as the lubricant
will chemically attack the battery cap.
WARNING
9. Check the proper polarity of the battery.
Aladin 2G can be damaged if you do not
insert the battery correctly. Insert the new
battery, with "+" pointing outwards, into
the battery compartment.
12. Appendix
69