Planning A Decompression Dive; Leaving The Dive Planner - Scubapro Aladin 2G Manual De Usuario

Confirm the displayed interval with
applicable).
With and
which you want to know the no-stop time.
If an MB level has been selected (L1-
L5), the MB no-stop time is shown.
Depths deeper than the MOD for the
selected gas (O
2
If the deco gas option is turned on,
only the depth between the MOD
of gas 1 and the MOD of gas d are
displayed.
On page 30 you will find further
information and safety considerations
regarding the no-dive warning.
9.2 Planning a
decompression dive
DEPTH
Confirm the desired depth with
1. Activate the dive planner for a no-stop
dive ->54.
2. Set the desired depth with
, then switch into decompression
planning by pushing
shows the bottom time (no-stop
time + 1 minute) and the appropriate
decompression information or level stop
data respectively.
SCUBAPRO ALADIN 2G
(if
set the depth for
mix) are not displayed.
DIVE TIME
NO STOP
CNS O %
2
and
. Aladin 2G
DEPTH
DIVE TIME
NO
DECO
STOP
CNS O
Set desired bottom time with
and
3. "Add" asks that you set the bottom
time. This is done with
Aladin 2G calculates the decompression
information for this set bottom time. If
an MB level (L1-5) is selected, Aladin 2G
calculates the level stop data.
CNS O % values higher than 199% will be
2
displayed as 199 %.
Ascent time greater than 99 minutes is
displayed as " – – "
Deco stop depth deeper than 27m (90ft) is
displayed as " – – : – – "
CNS O equal or greater than 75%:
2
CNS O % symbol starts flashing
2
CNS O equal or greater than 100%:
2
CNS O % symbol and CNS O
2
flashing.
MB level stop deeper than 27m (90ft): MB
level will be reduced.
9.3

Leaving the dive planner

By pushing once or twice
exit the dive planner. This also occurs after
three minutes without operation.
9. Dive planner
%
2
and .
% value are
2
you can
55