Machine Positioning; Electrical Connection - CHEFOOK 350 Manual De Instrucciones

5 INSTALLATION
Installation must be executed by qualified personnel in compliance with local, national and
European regulations.

5.3 MACHINE POSITIONING

Ensure that the machine is put on a flat stand with a suitable carrying capacity.
After unpacking the rolling machine, put it in the prepared location, keeping in mind the
minimum distances (see point 4.2) to be respected. Remove any polystyrene protections
and take off the protecting film (F). Avoid using tools which might damage the surfaces.
5.4 EQUIPMENT HOOK-UP
5.4.1

Electrical connection

Just connect the electricity-supply cable to the electricity network.
The electrical outlet must be easily accessible, no moving should be necessary.
! The electrical connection (plug) must be easily accessible, also after oven
installation.
The distance between the oven and the socket must be suitable, as not to cause tension in
the power supply cable. The cable, moreover, must not be located beneath the machine
support base.
If the electrical power supply cable is damaged, it must be replaced by the
!
technical assistance service or by a qualified technician to prevent any risks.
5.4.1.1 Ground connection
It is mandatory that the electrical system is equipped with a ground connection.
- 37 -
(F)