Models Icb427 And Icb427R Installation - Sub-Zero ICB424 Instrucciones De Instalación

Models ICB427 and ICB427R Installation

Models ICB427 and ICB427R Installation
Models ICB427 and ICB427R Installation
Make sure that the finished rough opening where the wine
storage unit is to be installed is properly prepared. Refer
to the installation specifications illustration for rough
opening dimensions, door swing clearance and electrical
placement for models ICB427 and ICB427R.
IMPORTANT NOTE: To operate properly, the door must
open a minimum of 90°. Use a minimum 51 mm filler in
corner installations to assure a 90° door opening. Allow
enough clearance in front of the unit for full door swing.
IMPORTANT NOTE: Make sure the floor under the unit is
level with the surrounding finished floor.
Do not load wine into the wine storage unit until the
installation is complete.
635 mm
ROUGH
OPENING
DEPTH
TOP VIEW
686 mm
2032 mm
ROUGH OPENING ROUGH OPENING WIDTH
HEIGHT
TO FINISHED
FLOORING
2019 mm
MIN HEIGHT
REQUIRED
LOCATE ELECTRICAL
WITHIN SHADED AREA
114
mm
394 mm
E
ANTI-TIP BRACKET
64 mm
FRONT VIEW
105˚
90˚ MAXIMUM
DOOR SWING
648
mm
711 mm 889 mm
DOOR CLEARANCE DOOR CLEARANCE
Door swing clearances are based on stainless steel door and
handle dimensions.
Electrical Requirements
A 220-240 V AC, 50/60 Hz, 10 amp circuit breaker and
electrical supply are required. A separate circuit, servicing
only this appliance, is required.
The power supply cord has a grounding plug, which must
be plugged into a mating ground ing-type wall recep tacle.
Follow local codes and ordinances when installing the
receptacle. For location of the electrical supply, refer to
the installation specifications illustration to the left.
IMPORTANT NOTE: A ground fault circuit interrupter
(GFCI) is not recommended and may cause interruption of
operation.
Do not use an extension cord or two-prong adapter.
Electrical ground is required on this appliance.
HOME ALARM SYSTEM
If a home alarm system is to be used, refer to wiring
connections on page 13. In addition to operating power,
the installer may also be required to supply a home
automation system lead to the unit. This is for a low-
voltage, low-current signal similar to door and window
sensor signals. Common, normally open and normally
closed contact configurations are provided.
Three 6 mm female spade connectors are located in the
compressor compartment and are accessible behind the
kickplate/grille on models ICB427 and ICB427R. A
minimum of 914 mm of lead wire should be provided for
each contact, exiting the back wall near the electrical
606 mm
outlet.
648 mm
Unpacking and Moving
Uncrate the unit, remove its wood base and discard the
shipping bolts that hold the wood base to the bottom of
the unit. Remove all packing materials and tape.
IMPORTANT NOTE: Do not discard the kickplate/grille,
anti-tip bracket and hardware. These items will be needed
for the installation.
All roller-assembly wine shelves should be removed to
reduce weight and prevent them from rolling. To remove,
pull the shelf out to its full extension, gently and evenly lift
up on both sides of the front of the shelf and remove.
Reverse the procedure to reinstall the shelf.
Retract the front leveling legs to allow you to move the
unit more easily during installation. You will extend the
leveling legs when the unit is in its final position to reduce
the possibility of the unit tipping forward.
Use an appliance dolly to move the wine storage unit.
Position the dolly at the side of the unit to prevent damage
to finished surfaces.
Before moving the wine storage unit into position,
protect any finished flooring with appropriate
materials.
10
10