Model Icbws-30 Installation; Site Preparation; Tools And Materials Required - Sub-Zero ICB424 Instrucciones De Instalación

Model ICBWS-30 Installation

Model ICBWS-30 Installation
Make sure that the actual equipment that was shipped to
you matches the design you are expecting to install.
Before you begin the installation process, check the exact
model number you need against the model number on the
shipping carton. If the unit you receive does not match
your requirements, contact your Sub-Zero dealer.
The model ICBWS-30 wine storage unit offers the fol-
lowing design alternatives—overlay, flush inset and stain-
less steel models. The overlay model has two design
applications—overlay and flush inset.
Each of these design options has specific installation
requirements, which means it is vital that the unit match
your planning and space needs. Refer to the overall
dimensions illustration for model ICBWS-30 shown in the
stainless steel design. Dimensions will be the same for all
design applications.
The door of the model ICBWS-30 opens to a maximum of
110°. A 90° door stop is shipped with the unit. The handle
depth reflects a tubular, curved or pro handle. For addi-
tional information, refer to the full-scale templates in the
Sub-Zero design guide.
2134
mm
762 610
mm mm
606
mm
BEHIND
432
FRAME
mm
794 mm*
60 mm
*Add 13 mm for flush inset application.

Site Preparation

Make sure that the finished rough opening where the wine
storage unit is being installed is properly prepared. Refer
to installation specifications on the following pages. These
specifications are identical for the overlay and stainless
steel applications. Installation specifications are different
for the flush inset application, whether you are using
custom panels or Sub-Zero accessory flush inset panels.
If you are installing two models ICBWS-30, or a model
ICBWS-30 and a built-in unit side by side in the overlay,
flush inset or stainless steel application, a filler strip is rec-
ommended. Add the filler strip width to the finished rough
opening dimension. For installation of two units side by
side without a filler strip, a dual installation kit will be
necessary.
IMPORTANT NOTE: To operate properly, the door must
open a minimum of 90°. Use a minimum 76 mm filler in
corner installations to assure a 90° door opening. Allow
enough clearance in front of the unit for full door swing.
IMPORTANT NOTE: Make sure the floor under the unit is
level with the surrounding finished floor.

TOOLS AND MATERIALS REQUIRED:

• Phillips screwdriver set
• Slotted screwdriver set
• Torx drive screwdriver set
• 1,2 m of 6,35 mm copper tubing and saddle valve for
the water line (4200880)—do not use self-piercing
valves
• Copper tubing cutter
• Level—0,6 m and 1,2 m recommended
• Appliance dolly able to support 317 kg and adequate
manpower to handle the weight of the unit
• Various sized pliers
• Wrench set
• Allen wrench set
• 11 mm hex bolt nut driver
• Crescent wrenches
• Cordless drill and assorted drill bits
• Masonite, plywood, 3,175 mm pressed fiberboard,
cardboard or other suitable material to protect finished
flooring
• Appropriate materials to cover and protect the home
and its furnishings during installation
16