Completing The Installation - Sub-Zero ICB424 Instrucciones De Instalación

Models ICB424 and ICB424FS Installation
Overlay Door Panel—Model ICB424
IMPORTANT NOTE: Install screws in all the mounting holes
in the door frame. The nature of the door panel with a
narrow outer rim and no connecting center member
requires the support provided by the glass door.
After the door panel installation is complete, apply the
cover patches or plugs provided over the holes on the
inside surface of the door.
The cover patches or plugs are part of the insulation
system on the door of the wine storage unit. Be sure
to cover all the holes in the door that were used.
The wine storage unit door is made with a sealed
double wall tempered glass core. The drill must not
contact this core when drilling. Be sure the hole is
centered on the small groove in the front of the door
frame and the drill passes squarely through the
frame. If you are inexperienced with drilling, fasten
the handle from the rear of the door panel only.
Hinge Adjustment
IMPORTANT NOTE: The wine storage unit must be
installed and leveled before door hinge adjustments can
be made.
The top and bottom cabinet hinges on models ICB424 and
ICB424FS are held in place with three permanent adjust-
ment screws and two shipping screws. Refer to the illus-
trations below. The shipping screws must be removed and
discarded to adjust the door alignment and fit. If no
adjustments are necessary, it is recommended that all five
screws remain in place.
On the model ICB424FS, only the bottom door hinge can
be adjusted. Remove and discard the two shipping screws
and loosen the three hinge screws to adjust the door.
Refer to illustration 12.
TOP DOOR HINGE
SHIPPING
SCREWS
BOTTOM
DOOR HINGE
SHIPPING
Top hinge. Bottom hinge.

Completing the Installation

IMPORTANT NOTE: When you have completed the instal-
lation of the model ICB424 or ICB424FS wine storage unit,
refer to page 28 for an installation checklist and page 29
for service information.
SCREWS
9
subzero.com