Anti-Tip Bracket Installation - Sub-Zero ICB424 Instrucciones De Instalación

Models ICB424 and ICB424FS Installation

Anti-Tip Bracket Installation

To prevent the unit from tipping forward and provide
a stable installation, the unit must be secured in
place with the anti-tip bracket.
An anti-tip bracket and hardware is provided with the wine
storage unit. The anti-tip bracket must be installed on a
solid base to prevent tipover in case several loaded wine
shelves are extended at the same time.
MODEL ICB424
The anti-tip bracket should be attached to the wall behind
the unit with the bracket flange located immediately above
the top of the unit. Refer to the illustration below.
A smaller metal 'countertop' bracket is also provided with
the model ICB424, for installations that need to be
modified to provide a secure surface for attaching the
bracket. This bracket will secure the front of the unit to the
underside of the countertop, above the unit. Refer to the
illustration below.
ANTI-TIP
COUNTERTOP
BRACKET BRACKET
6 mm
Anti-tip bracket—model Countertop bracket
ICB424.
MODEL ICB424FS
If you are installing the model ICB424FS in a space deeper
than 625 mm, the anti-tip bracket must be installed no
more than 625 mm deep, so it engages the unit properly. It
is important that this measurement be made from the front
surface of the door, to the back of the anti-tip bracket.
Refer to the illustration.
ANTI-TIP BRACKET
Anti-tip bracket—model
ICB424FS.
WOOD FLOOR APPLICATIONS
Use the four #12 x 64 mm wood screws and the four
6 mm flat washers provided. Drill pilot holes 5 mm
diameter maximum, and be sure that the screws penetrate
through the flooring material and into the wall plate a
minimum of 19 mm. Be sure that the screws hold tight.
Refer to the illustration below.
CONCRETE FLOOR APPLICATIONS
Use the two 10 mm x 95 mm concrete wedge anchors,
two #12 x 64 mm wood screws and two 6 mm flat
washers provided. Be sure that the anchors and screws
hold tight. Refer to the illustration below.
IMPORTANT NOTE: In some installations the subflooring
or finished floor may require angling the wood screws
used to fasten the anti-tip bracket to the back wall.
Make sure that there are no electrical wires in the
area which the screws could penetrate.
610
mm
C L
C L
310
310
310 mm
310 mm
mm
mm
FINISHED FLOORING
PLANCHER FINI
UNDERLAYMENT
SUPPORT
WALL PLATE
PLAQUE MURALE
SUBFLOORING
PLANCHER BRUT
WOOD FLOOR
PLANCHER EN BOIS
Wood floors. Concrete floors.
INSTALLATION FOR CONCRETE WEDGE ANCHORS
1) Drill a 10 mm diameter hole any depth exceeding the
minimum embedment. Clean the hole or continue
drilling additional depth to accommodate drill fines.
Use a carbide drill bit manufactured within ANSI
B94.12-77.
2) Assemble the washer and nut flush with the end of
anchor to protect threads. Drive the anchor through the
material to be fastened until the washer is flush with
the surface material.
3) Expand the anchor by tightening the nut 3–5 turns past
hand-tight position or to 35 newton meters of torque.
Always wear safety glasses and use other necessary
protective devices or apparel when installing or
working with anchors.
Anchors are not recommended for use in lightweight
masonry material such as block or brick, or for use
in new concrete which has not had sufficient time to
cure. The use of core drills is not recommended to
drill holes for the anchors.
610
mm
6