Interpump Group Pratissoli SM Serie Manual De Reparación página 42

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 114
Assemble the reduction gear box (and relative seal) using an
extractor hammer (pos. , Fig. 63).
Tighten the 8 M10x40 screws (pos. , Fig. 64).
Calibrate the screws with a torque wrench as indicated in
chapter 3 SCREW TIGHTENING CALIBRATION.
Remove the tool for blocking the con-rods code 27566200
(pos. , Fig. 32).
Insert the upper half-bearings between the con-rods and the
shaft (pos. , Fig. 65).
For proper assembly of the half-bearings, ensure
that the reference tab on the half-bearings are
positioned in their housing on the half support
(pos. , Fig. 66).
Fig. 62
Fig. 63
Apply the lower half-bearings to the caps (pos. , Fig. 67)
ensuring that the half-bearing reference notches are
positioned in their housing on the cap (pos. , Fig. 67).
Fasten the caps to the half supports by means of M10x1.5x80
screws (pos. , Fig. 68).
Note the correct assembly direction of the caps.
Numbering must be turned upward.
Calibrate the screws with a torque wrench as indicated in
chapter 3 SCREW TIGHTENING CALIBRATION, bringing the
screws to tightening torque at the same time.
Fig. 64
42
Fig. 65
Fig. 66
Fig. 67

Publicidad

Tabla de contenido
loading

Tabla de contenido