Care And Cleaning - Kenwood CCL50 Manual De Instrucciones

Care and Cleaning

Refer to Illustration
instructions.
Always switch off and unplug before
cleaning.
Remove the lid and tool from the bowl
before cleaning.
Some foods, e.g. carrot, may discolour
the plastic. Rubbing with a cloth dipped
in vegetable oil may help to remove
discolouration.
To assist in removing odours from
strong smelling foods, air dry the parts
after washing.
When not in use, the Direct Prep discs
can be stored in the storage bag
supplied.
Never use abrasives.
Certain ingredients, such as turmeric,
may cause staining. This will not affect
the performance of your appliance.
Power Unit
Wipe with a damp cloth, then dry.
Never use abrasives or immerse in
water.
Bowl Temperature Sensors
Wipe with a damp cloth then dry
thoroughly. Never use abrasives or
sharp instruments to clean the sensors.
Bowl/Stir Tool/Knife Blade/Whisk Tool
Use the Rinse pre-set programme
to quickly clean the bowl before
taking apart for cleaning. For best
results, always take the bowl apart for
cleaning and dry thoroughly before
re-assembling.
Wash the parts by hand or in your
dishwasher. Then dry thoroughly.
If food sticks or burns on the inside of
the bowl, remove as much as possible
using a spatula. Fill the bowl with warm
soapy water and allow to soak. Remove
any stubborn deposits using a cleaning
brush. Any discolouration of the bowl
will not affect its performance.
P
for cleaning
Bowl Drive Shaft Assembly/
Slow Cook Plug
1 Unlock the drive shaft nut on the
underside of the bowl by turning in an
anti-clockwise direction.
2 Then lift out the drive shaft or slow
cook plug.
3 Remove and wash the sealing ring.
4 Brush the bowl drive assembly or slow
cook plug clean with hot soapy water,
then rinse thoroughly under the tap.
5 Ensure the seal is refitted to the drive
shaft or slow cook plug correctly before
refitting to the bowl.
Lid
Always dismantle the lid before
cleaning:
1 Remove the filler cap.
2 Push the lid inner section out.
3 Remove the seal from the lid inner
section.
After washing, fit the seal back on to
the outer lid section with the thicker
edge uppermost and reverse the above
procedure.
Note: leaking from the lid will occur if the
seal is not fitted correctly or damaged.
Direct Prep
Dismantle the attachment fully before
cleaning.
For easier cleaning, always wash the
parts immediately after use.
Handle the cutting discs with care –
they are extremely sharp.
To remove the lid from the base,
hold by the feed tube and turn in an
anticlockwise direction. Then lift off.
Tower: do not immerse in water. If
the tower is accidentally immersed in
water, ensure that all the water has
drained out before reassembling the
attachment.
Steamer Tray/Condensation Trap/
Weighing Bowl
Wash the parts, then dry thoroughly.
22