Im Nailing Femur: Unilateral Skeletal Traction 6875 Hana; Surgery Table Set-Up - Mizuhosi hana 6875 Manual Del Propietário

8.9 IM Nailing Femur: Unilateral Skeletal Traction 6875 hana

Figure 31: Patient positioned for Right IM Nailing Femur supine with skeletal traction and well leg retained in
traction boot
Instructions provided are for suggested set-ups. Final determination of patient positioning
and set-up is at the discretion of the surgeon and surgical team.
1. Ensure all (4) caster floor locks are in the locked position.
2. Attach radiolucent leg spars (6875-360) right & (6875-350) left to the table and lock in
place. Refer to section 8.1.
3. Place pelvic pad (6875-7129) onto table. Attach lower leg support (6850-170) to non-
operative leg spar with accessory clamp (5855-61) and lock in place.
4. Attach optional patient transfer board (6875-742) by clamping the device to the leg
spar on the side of the table from which the patient will be transferred to the table.
Refer to section 8.6.
5. Adjust table height to appropriate position to transfer patient from patient stretcher.
6. Attach appropriate traction boot (6850-485) small, or (6850-486) large to patients'
non-operative foot while on patient stretcher.
7. Transfer patient to the table in supine position, insert well padded perineal post (6850-
413), move the patient to establish firm contact with the perineal post, and secure with
patient safety strap (5840-44).
8. Place non-operative leg traction boot into traction mount on the non-operative leg
spar.
9. Install arm board with pad (6875-292) to each side of the table and position patient's
arms out to the side or attach arm board with pad (6875-292) to the non operative side
of the table and optional cross arm support (5857) using clark socket (5393) to the
non-operative side of the table and secure the patient's arms.
10. Attach a pin holder (not provided) to the traction mount on the operative leg spar using
the traction device hook (6850-114) and traction hook extension (6875-399). Position
the patient's leg.
11. Remove patient transfer assembly (6875-742) by unclamping it from the leg spar and
sliding it out from underneath the fully positioned patient.
MIZUHOSI 2009
®

Surgery Table Set-Up

38 NW0508 Rev. D