Motion Control Module - Mizuhosi hana 6875 Manual Del Propietário

10.3 Motion Control Module

Part number: 100VAC 6875-4004, 120VAC 6875-4001, 230VAC 6875-4000
Figure 45: Motion control module
1. Disconnect hand pendant bayonet-type connector from front panel.
2. Remove motion-control module cover by removing four #10 screws.
3. Remove two ¼-inch screws.
4. Slide-out motion-control module away from base about six inches.
Figure 46: Bayonet connectors
5. Disconnect the six bayonet-type electrical connectors.
MIZUHOSI 2009 64 NW0508 Rev. D