Connecting Nasal Cannula; Turning On; Choosing A Preferred Language - GCE Zen-O RS-00500 Manual Del Usuario

7.1. Connecting Nasal Cannula

CAUTION: Replace the cannula on a regular basis.
Check with your home oxygen provider or clinician
to determine how often the cannula should be re-
placed.
CAUTION: Always follow cannula manufacturer's in-
structions for proper use.
Connect the tubing to the cannula port as shown in
Fig. 5.
To connect the cannula to the patient, position the
cannula tips in patient's nostrils and pass tubing over
both ears and under chin. Follow manufacturer's in-
structions.
Slide adapter up tubing to adjust for comfort and fit.
Once the cannula is secured, breathe normally
through the nose. Zen-O™ will detect a breath and
deliver the oxygen during inhalation.
IMPORTANT: Improper cannula placement may result
in the device being unable to detect all respiratory ef-
forts of the patient. Ensure cannula is connected se-
curely and it has been fully inserted.

7.2. Turning On

• To turn the device on, press the power key
• The concentrator will chirp and the green, yellow, and red LEDs will flash once, while the
screen displays the device name.
Red LED - indicates a warning danger and/or a need for urgent action
Yellow LED - indicates caution or attention required
Green LED - indicates device is on. The green LED will then stay lit.
IMPORTANT: No adjustments can be made until the startup sequence is completed.

7.3. Choosing a Preferred Language

• While the device is on, hold down the plus
seconds until it says "Language:".
• Next cycle through the available languages using the plus
• When the desired language is shown, press the mode button
change the language and go back to the normal flow screen.
.
and mute buttons together for about four
or minus
11/185
Cannula
port
Fig. 5
Fig. 6
buttons.
to select. The device will
EN