Tabla de contenido
Publicidad
3
4
5
14
Installation of the machine
For models with the inflating device built into the column also:
F .
Connect the diameter 8 hose (12, Fig.2a), from the column
to the inflating pedal tap as illustrated.
diagrams supplied in the Spare Parts Manual.
G .
Refit the column base guard "1" and all of the parts
previously removed.
H.
Secure the tyre changer to the floor.
2.3 Transporting the machine at site
Suitable lifting cables and lifting facilities or a fork-lift truck
should be used for transporting the machine. Always mind
the centre of gravity of the machine.
Fig. 3 Transport using a fork-lift truck
•
•
•
•
Fig. 4 Transport using lifting facilities
•
•
•
2.4 Fitting the bead breaker
4
Fig. 5 Fitting the bead breaker
1 Bead breaker. 2 Hook. 3 Spring. 4 Bead breaker
5
support. 5 Holes in bead breaker and support. 6 Pin.
7 Self-locking hub nut.
7
Place the bead breaker (Fig. 5, Item 1) inside the
3
5
support (Item 4). The holes (Item 5) of bead breaker
and support must match.
2
Lightly grease pin (Item 6). Fix the bead breaker (Item 1)
on support (Item 4) with pin (Item 6) and Self-locking hub
nut (Item 7).
Attach spring (Item 3) to the hook on the frame and
6
connect it to the hook (Item 2) on the bead breaker.
1
Operation manual
Note: For hose connections, see the pneumatic
For transport of the machine secure machine post and
mounting arm against moving out of place.
Tilt the machine slightly.
Drive the fork-lift truck below.
Lower the machine on the fork-lift truck and position
such that it will not turn over during transport (mind the
centre of gravity of the machine).
For transport of the machine secure machine post and
mounting arm against moving out of place.
Position the lifting cables or other suitable lifting facilities
on the machine as illustrated in Fig. 4.
When lifting the machine, make sure that the lifting
cables are properly positioned (mind the centre of gravity
of the machine) and that the machine does not turn
over.
T 3300-24
Publicidad
Tabla de contenido
