General Information; Symbols Used In This Document; Other Important Notes; Receiving The Product - Grundfos LFE Instrucciones De Instalación Y Funcionamiento

2. General information

2.1 Symbols used in this document

DANGER
Indicates a hazardous situation which, if not avoided,
will result in death or serious personal injury.
WARNING
Indicates a hazardous situation which, if not avoided,
could result in death or serious personal injury.
CAUTION
Indicates a hazardous situation which, if not avoided,
could result in minor or moderate personal injury.
The text accompanying the three hazard symbols DANGER,
WARNING and CAUTION will be structured in the following way:
SIGNAL WORD
Description of hazard
Consequence of ignoring the warning.
- Action to avoid the hazard.
Example
DANGER
Electric shock
Death or serious personal injury.
- Before starting any work on the product, make
sure that the power supply has been switched off
and that it cannot be accidentally switched on.

2.2 Other important notes

A blue or grey circle with a white graphical symbol
indicates that an action must be taken to avoid a
hazard.
A red or grey circle with a diagonal bar, possibly with
a black graphical symbol, indicates that an action
must not be taken or must be stopped.
If these instructions are not observed, it may result
in malfunction or damage to the equipment.
Notes or instructions that make the work easier and
ensure safe operation.
All manuals and user guides at all-guides.com

3. Receiving the product

3.1 Unpacking the product

3.2 Inspecting the product

•
•
•
•

3.3 Temporary storage after delivery

•
•
•
•
WARNING
Overhead load
Death or serious personal injury
- Do not lift the unit by the eye bolts on the motor.
Unload and handle the unit with a sling.
Check that the product received is in accordance with the
order.
Check that the voltage, phase and frequency of the product
match the voltage, phase and frequency of the installation site.
See section
7.3 Pump identification.
Check the product for defects and damage immediately upon
arrival. Any accessories ordered will be packed in a separate
container and shipped with the product.
If any equipment is damaged in transit, promptly report this to
the carrier's agent. Make complete notations on the freight bill.
If the product is not to be installed and operated immediately
after receiving it, store it in a clean, dry area at a moderate
ambient temperature.
Rotate the shaft by hand periodically, at least weekly, to coat
the bearing with lubricant to retard oxidation and corrosion.
Follow the motor manufacturer's storage recommendations
where applicable.
During storage and transport maintain an ambient temperature
from -13 to +158 °F (-25 to +70 °C) for the E-motor. At
temperatures below the prescribed temperature, the E-motor
must be equipped with a anti-condensation heater. This could
be an external heating element or an incorporated functionality
of the E-motor.
5