Brake Cam Assembly Replacement - Stryker 1037 Manual De Instrucciones

BRAKE CAM ASSEMBLY REPLACEMENT

Tools Required:
• Needle Nose Pliers
• Bungee Cords
Procedure:
1 . Pump the stretcher all the way up .
2 . Raise both siderails to the up and latched position .
3 . Using bungee cords, support the raised base hood .
4 . Put the base brake/steer pedal in the neutral position .
5 . Using needle nose pliers, remove the rue clip and clevis pin that secure the brake cam assembly to the brake rod .
Save all parts for reinstallation .
6 . Using needle nose pliers, remove the rue clip and washer from the top bearing pivot support . Save all parts for
reinstallation .
7 . Using needle nose pliers, remove the rue clip and plastic washer from the bottom support . Save the rue clip for
reinstallation .
8 . Raise the brake cam link off of the brake rod actuator and slowly pull outward on the brake cam assembly . Discard
the brake cam assembly .
9 . Reverse steps to reinstall .
Note: When installing the new brake cam assembly, install the bottom slightly first and then push downward and inward
to install under the top bearing .
10 . Verify proper operation of the unit before returning it to service .
www.stryker.com
Service Information
1037-009-006 REV D
Return To Table of Contents
1-17
English