BIG WHEEL REMOVAL (NON FOUR-SIDED BRAKES)
Tools Required:
• Large Standard Screwdriver
• Small Standard Screwdriver
• Bungee Cords
Procedure:
1 .
Lift the base hood and separate the Velcro that holds the base hood to the base frame . Support the hood from the
litter using bungee cords so it is out of the way .
2 .
Using a large standard screwdriver, remove the hub cap in the center of the wheel .
3 .
Using a small standard screwdriver, remove the spiral retaining ring from the groove on the wheel axle .
4 .
Remove the Big Wheel .
5 .
Reverse steps to reinstall the Big Wheel .
6 .
Verify proper operation of the unit before returning it to service .
BIG WHEEL REMOVAL (FOUR-SIDED BRAKES)
Tools Required:
• Large Standard Screwdriver
• 7/32" Roll Pin Punch
• Bungee Cords
Procedure:
1 .
Lift the base hood and separate the Velcro that holds the base hood to the base frame . Support the hood from the
litter using bungee cords so it is out of the way .
2 .
Using a large standard screwdriver, remove the hub cap in the center of the wheel .
3 .
Using a 7/32" roll pin punch, remove the tapered groove pin from the pedal .
Note: The pin is tapered, so it must be driven from the bottom up .
4 .
Remove the Big Wheel .
5 .
Reverse steps to reinstall the Big Wheel .
6 .
Verify proper operation of the unit before returning it to service .
www.stryker.com
Service Information
1037-009-006 REV D
Return To Table of Contents
1-29
English