Brake Rod Replacement - Fifth Wheel Only - Stryker 1037 Manual De Instrucciones

English

BRAKE ROD REPLACEMENT - FIFTH WHEEL ONLY

Tools Required:
• Hammer
• 7/32" #7 Roll Pin Punch
• Needle Nose Pliers
• Bungee Cords
Procedure:
1 . Pump the stretcher all the way up .
2 . Raise both siderails to the up and latched position .
3 . Using bungee cords, support the raised base hood .
4 . Put the brake/steer pedal into the steer position .
5 . Using a hammer and a 7/32" roll pin punch, remove the eight roll pins from pedal to pedal on the brake rod .
6 . Using needle nose pliers, remove the rue clip and clevis pin that secure the brake link to the brake rod .
7 . Using your hands, grasp the brake rod and remove each brake/steer pedal . Save the pedals for reinstallation .
8 . Remove the brake rod from the base .
9 . Install the new brake rod and then install the roll pin into the head end timing link arm first .
10 . Reverse steps to reinstall .
11 . Verify proper operation of the unit before returning it to service .
Return To Table of Contents
1-18
Service Information
1037-009-006 REV D www.stryker.com