Acquisition Procedure - Roger Technology EDGE1/BOX Instrucciones Y Advertencias Para El Instalador

11.2

Acquisition procedure:

PROG
AP P-
x4 s 1 click
x2 s
AU AU to to AU to
• Press and hold PROG for 4 seconds.
• Press PROG again.
• MOTOR 1 starts opening at low speed.
• After the delay time set with parameter
•
for 2 s.
• When the message
delay set with parameter
If the acquisition procedure is completed successfully, the display enters the command and safety device state display
mode.
• acquisition error. Press the TEST button to clear the error, and check the safety device in alarm state.
• travel length error. Press TEST to clear the error, and check that both gate leaves are fully closed before
launching a new acquisition procedure.
For more information, see chapter 15 "Alarms and faults".
64
PROG
AU to
2
PARAM. 26
MOTOR 2 DELAY
CLOSING TIME
is shown on the display.
is shown on the display.
(with a default time setting of 3 s), MOTOR 2 starts an opening manoeuvre.
(default setting 5 s), MOTOR 1 closes until the gate closed mechanical stop is reached.
1
PARAM. 25
MOTOR 1 DELAY
OPENING TIME
2
1
MOTOR 1 CLOSED
CLOSING
2
1
MOTOR 2
OPEN
OPENING
Sì