Mechanical Release; Position Recovery Without The Absolute Encoder - Roger Technology EDGE1/BOX Instrucciones Y Advertencias Para El Instalador

the - button to return through the previous parameters.
• In INFO mode, the automation system may be activated to test operation in real time.
• The two motors may be controlled independently in OPERATOR PRESENT mode, ignoring the position data request
message " " and bypassing the safety devices installed (photocells, sensing edges and STOP button) with the
appear on the display. MOTOR 2 is controllable when the messages
the display.
Example:
p1
or
p2
• THE MOTOR in question is activated on opening by pressing the
"DOWN ARROW" key.
•
button, release within 1 second and then press and hold. The motor stops as soon as the button is released.
WARNING: during the check, the motor revolution count (position) is updated but the gate leaf alignment
control function may cause problems. Before exiting INFO, make sure that the gate leaves are correctly aligned.
• Press and hold the TEST button for a few seconds to exit INFO mode.
17

Mechanical release

In the event of power failure, the gate may be unlocked by following the instructions given in the use and maintenance
For SMARTY 5R5 / SMARTY 7R
closed without releasing it, with the motor idle.
The SMARTY/EMA absolute encoder (installed as standard on SMARTY REVERSIBLE units and optional on SMARTY
IRREVERSIBLE units) allows the controller to reacquire the position immediately after each new command signal
received.
18

Position recovery WITHOUT the absolute encoder

consecutive times, the control unit starts a manoeuvre in position recovery mode.
duty cycle than normal (3 s on, 1.5 s off).
The control unit recovers the installation data during this procedure. Warning: Do not use any controls until the gate
has performed a complete manoeuvre for both leaves.
If the gate is released in the completely open or completely closed position with the control unit powered, always return
the gate leaves into their original positions before locking the gate release again. The gate will resume normal operation
WARNING
parameters to be lost (see parameters
necessary.
Should the wings not be returned to the same position in which they were before the manual handling, the data relative
1. The wings movement gets inverted on the mechanical strike plates (obstacle detection).
2.
opens).
3.
• activates the position recovery mode;
1-PRESS 2-RELEASE
OPEN CLOSE OPEN
or
in INFO mode). In this case, a position recovery procedure is
,
3-RE-PRESS
CLOSE OPEN
or
within 1 s
"UP ARROW" key, or on closure by pressing the
, the gate can be manually opened and
, , and
, and appear on
CLOSE
or
83