To Install The New Seals And O-Rings - Agilent TPS-compact Instrucciones De Uso

Technical Information

To Install the new Seals and O-Rings

1
Unpack the Tip-Seals. Two tip seals are provided in the kit; one fits the orbiting
scroll and the other fits the out-board housing scroll.
2
Install the correct tip seal into the groove of the orbiting scroll by:
a
b
3
Install the correct tip seal into the groove of the outboard housing scroll as in step 3.
4
Place the new main O-ring into the groove in the frame.
5
Ensure that the groove is clean.
6
Ensure the sealing face of the outboard hous-ing is clean. Carefully replace the
outboard housing by lining up the locating pins. Ensure the tip seal has not
fallen out of its groove.
7
Reinstall (4) M5 bolts (B) and torque the (4) M5 bolts to 5.6 Nm (50 in-lb).
8
Unlock the upper part of TPS-compact by sliding the small lever you can find on
the bottom side of TPS-compact.
9
Reconnect the TPS-compact to the electrical power mains.
Agilent TPS-compact User Manual
Facing the white plastic surface upwards and inserting the foam backing
into the groove. Start from the center and work outward.
Cutting the tip seal off about 1/8" (3 mm) from the outer end of the groove.
229