Logging In; Non-Permanent Settings - Astute Medical ASTUTE140 METER Manual Del Usuario

ASTUTE140
®
If the self test fails, an error message will be displayed. Press the right soft key to select
OK and close the error message, and then restart the ASTUTE140
off and back on again (to power off the meter, toggle the power switch upwards and it
should immediately shut down). If after restarting the ASTUTE140
fails again, contact Astute Technical Support (See "Contacting Astute Medical, Inc." on
p. 7 for contact information).
ASTUTE140 Meters are factory-calibrated to ensure that the same NEPHROCHECK
®
Test cartridge will provide equivalent results if read in different meters. The End User is
not required to calibrate the meter.

Logging In

In order to operate the ASTUTE140
and password. This requirement protects access to patient information stored in the
ASTUTE140 Meter's memory.
®
After successfully powering on the ASTUTE140
automatically appear. Perform the following steps to log in to the system:
1. When the Log In screen is displayed, User ID is highlighted. Enter your user
ID using the numeric keypad or an external keyboard or barcode reader (if
connected).
2. After entering your user ID, use the
3. Use the numeric keypad or an external keyboard (if connected) to enter your
password.
4. Confirm that the correct log in information is displayed. To make changes to the
entries, use the
key to delete the incorrect entry, and then use the numeric keypad or an external
keyboard (if connected) to change the entries. Press the right soft key to accept
all entries.

Non-Permanent Settings

Although the default settings for the ASTUTE140
through the Supervisor Menu, Operator users can select some settings from predefined
values that are valid until the meter is switched off or until the Operator is logged out.
At such time the settings will revert to the default settings selected by the Supervisor.
To temporarily set the date and time formats, the language, and to turn the beeper on or
off, follow these steps:
1. Press the
immediately after successful log in, the Main Menu will automatically be
displayed).
46
Meter Operation
Meter, the user must log in with a unique user ID
®
keys to highlight the field to be changed. Use the
key to display the Main Menu (if registering the EQC device
Meter by turning it
®
® Meter the self test
® Meter, the Log In screen will
key to highlight the Password field.
Meter are set by the Supervisor
®
©Astute Medical, Inc. 2020 PN 300153MULTI Rev A 2020/01/07
ASTUTE140 Meter
®
®