Testing A Patient Sample - Astute Medical ASTUTE140 METER Manual Del Usuario

ASTUTE140
®

Testing a Patient Sample

Assay-specific test cartridges that are uniquely compatible with the ASTUTE140
Meter are used to test patient samples. The test cartridges approved for use with the
ASTUTE140 Meter should not be used with any other testing device. Similarly, only
®
test cartridges approved for use with the ASTUTE140
approved tests for use with the ASTUTE140
cartridges, go to www.astutemedical.com or consult your Astute Medical, Inc. sales
representative.
NOTE: Unless modified by the Supervisor, the Run Patient option will be greyed out
(unavailable) until valid ASTUTE140
NEPHROCHECK
Each new test lot must be registered prior to use of any NEPHROCHECK
cartridges from that lot (See "Test Lot Registration" on p. 52 for instructions).
To test a patient sample, perform the following steps:
1. Press the
immediately after successful log in, the Main Menu will automatically be
displayed).
2. When the Main Menu is displayed, use the navigation keys to highlight the Run
Patient icon. Press the right soft key to select Run Patient.
3. When the Run Patient screen is displayed, Patient ID will be highlighted. Enter
the Patient ID manually using the numeric keypad or an external keyboard (if
connected) or, if applicable, by scanning the barcode on the patient sample with
the optional barcode reader (if connected).
62
Meter Operation
Meter Electronic Quality Control (EQC) and
®
Liquid Control Kit results are detected.
®
key to display the Main Menu (if running patient sample
Meter can be used. For a list of
®
Meter and to purchase assay-specific test
®
ASTUTE140
®
Test
®
Figure 66.
Main Menu screen
with Run Patient icon
highlighted
©Astute Medical, Inc. 2020 PN 300153MULTI Rev A 2020/01/07
Meter
®